Dafydd (dgh) wrote,
Dafydd
dgh

removing cartridge bearings

Finding advice on removing a cartridge bearing from a bicycle wheel proved surprisingly difficult recently. Even a fairly recent and comprehensive bicycle repair manual that I had to hand didn't say anything about it.

It turns out the way to do it is to remove any end caps and locknuts and washers and nuts and then bang the end of the axle really hard against a piece of wood. You will probably make dents in the piece of wood.

This works because cartridge bearings are pressure fit both to the hub and to the axle. (This is really neat!) Both the hub and the axle are stepped to hold the cartridge in place. A hard enough bang will simultaneously make the step on the upmost side of the axle pop the upmost cartridge from the hub and make the step on the downmost side of the hub pop the downmost cartridge from the axle. You can then pull the axle out and remove the other cartridge by poking through a screwdriver or similar and tapping with a mallet.
Tags: bicycle, pgo
Subscribe

  • Breakdown: Markdown for presentations

    Recently I've been giving a few talks, and anticipate giving several more in the near future, and have been getting annoyed at how time-consuming…

  • (no subject)

    Futility Closet, ever edifying, notes that the word “ravine” is reversed when rot13 is applied. Are there other words that have the…

  • recent hacking

    crosswords I enjoy crosswords very much, and for a while I've been loading the free Houston Chronicle crosswords in Xword. Although they…

  • Post a new comment

    Error

    Anonymous comments are disabled in this journal

    default userpic

    Your IP address will be recorded 

  • 4 comments